TIAGO TIGOR BSVI - SERVICE MANUAL - DTC 24-12-2021

TATA BSVI Gasoline Program – EMS ECU Bosch DTC Troubleshooting Service Manual Version: 1.2 Date: 18-12-2019 Prepared By: Sunita Mandlik Checked By: Yeshwant Jadhav Approved By: Satish Kumar Document Part No: 2921 02 xxx xxxx Page: 1133 of 1498 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. Trouble Shooting: Step Checks IF YES IF NO 1. Short Circuit between CAN HIGH (132) to Vbatt Rectify the wiring harness Go to next step 2 Short Circuit between CAN HIGH (132) to GND, Rectify the wiring harness Go to next step 3 Short Circuit between CAN LOW (144) to Vbatt Rectify the wiring harness Go to next step 4 Short Circuit between CAL_H (144) to GND, Rectify the wiring harness Go to next step 6 Check the resistance between pin 132 & pin 144 of the vehicle connector it should be approximately 60 ohms Go to next step Check for terminal back out of the wiring harness at ECU & instrument cluster CAN wire 7 There should be continuity between vehicle side wiring harness with following pins. IPC CAN HIGH (pin. 6) to ECM CAN HIGH (C1, 132) and IPC CAN LOW (pin. 5) to ECM CAN LOW (C1, 144) Continuity should be there. Go to next step Establish continuity as per the Circuit schematic. 8 If fault still persists Replace EMS ECU Repeat above procedure for reconfirmation