TIAGO TIGOR BSVI - SERVICE MANUAL - DTC 24-12-2021

TATA BSVI Gasoline Program – EMS ECU Bosch DTC Troubleshooting Service Manual Version: 1.2 Date: 18-12-2019 Prepared By: Sunita Mandlik Checked By: Yeshwant Jadhav Approved By: Satish Kumar Document Part No: 2921 02 xxx xxxx Page: 1132 of 1498 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. U0402-64: Invalid Data Received From TCM-signal plausibility failure ISO Code U0402-64 Customer Symptom Engine come to forced neutral condition Fault Effects (On Vehicle) Vehicle will not move (remain standstill) as it comes to forced neutral condition from transmission ECU Lamp Status (If Any) No lampON after 1 drive cycles Fault Detection Condition Invalid Data Received from TCM-signal calculation failure Normal Operating Condition Vehicle mobilized Probable Trouble Area Implausible torque requests come from TCU Healing Condition After 1 engine cycles Fault permanent deletion 1. Scan tool Service 14. 2. Stack Over Flow. 3. 40 warm up cycles. 4. ECU Flashing. 5. ECU power fail Preliminary Checks: 1. Check ECM is communicating with TML diagnostic DTC or not. 2. If not, check for short conditions between CAN HIGH-CAN LOW, CAN HIGH-GND, CAN LOW-GND, CAN HIGH-Vbatt and CAN LOW-GND at ECM vehicle side wiring harness (pin details are provided with schematic in the document). There should not be any short Circuit conditions. 3. There should be continuity between vehicle side wiring harness with following pins. i. IPC CAN HIGH (pin. 6) to ECM CAN HIGH (C1, 132) and IPC CAN LOW (pin. 5) to ECM CAN LOW (C1, 144) Continuity should be there. 4. Read IVN DTCs in ECM after IGN ON condition with TML diagnostic tool. 5. CHECK TCU for any error logs or abnormal behavior 6. If the following signal is logged this error will appear: i. Implausible torque requests come from TCU