TIAGO

STEERING 22 High beam does not come on when flash switch is activated 1. Combi Switch connector loose Fix the connector properly 2. Flash switch faulty Replace combi-switch 2 FRONT FOG LAMP (HIGH END) CONTROLLED BY BCM CONDITION POSSIBLE CAUSE CORRECTION/REFERENCE ITEM Single LAMP not working 1. Grounding point loose Tighten grounding properly 2. Bulb fused Replace bulb 3. No output from BCM Refer BCM Diagnosis Both lamps not working 1.Fog lamp fuse (10A) in cabin F/R box blown Check for short in the circuit and then replace the fuse 2.Front fog lamp relay(20A) in Engine F/R Box faulty Replace relay 3. Front fog lamp switch faulty Replace switch 4. No output from BCM Refer BCM Diagnosis 5. Front fog lamp switch ground point loose Tighten grounding properly 6. Bulb loose/fused Fix bulb properly. Replace if blown 3 INDICATOR LAMP WARNING LAMP AND OTHER LAMPS CONDITION POSSIBLE CAUSE CORRECTION/REFERENCE ITEM Front right / left signal lamps not working 1. Grounding point loose Tighten the grounding properly 2. 8 pole Head Lamp connector at the lamp loose Fix the connector properly 3. Bulb fused Fix the bulb properly. Replace bulb if blown Rear right / left turn signal lamps not working 1. Grounding point loose Tighten grounding properly 2. 8 pole Rear Lamp Connector loose Fix the connector properly 3. Bulb fused Fix the bulb properly. Replace bulb if blown Both Turn Indicators not working 1. Flasher fuse (10A) in cabin fuse box loose/blown(BASE & MID) Fix fuse properly in the base. Replace fuse if blown 2. Flasher in cabin fuse box faulty(BASE & MID) Replace Flasher