ZEST BOLT Service Manual

SRS 12 15. Only use the diagnostic tool to probe faults in the Airbag system, NEVER use electrical probing instruments like multimeter as the probing current may deploy the airbag. 16. All the faults in the ECU should be cleared only using a diagnostic tool. 17. Remember to reset the SRS warning lamp after conducting a repair by checking for any errors using the diagnostic tool. 18. Never attach anything to the airbag cover or allow anything to rest on top of the airbag module. 19. Always store airbag module in a dry, cool and secured area. 20. Never attempt to modify any splice or repair SRS wiring harness. 21. Always ensure airbag wiring is routed correctly. Be careful to avoid trapping or pinching the airbag wiring. Look for possible points of chafing. 22. Ensure all airbag harness connectors are mated correctly and securely fastened. Do not leave the connectors hanging loose or allow SRS components to hang from their harnesses. 10.6 REPAIRS NOTE: Before performing any repairs on SRS components please refer Safety Precautions given in previous section. 10.6.1 DRIVER AIRBAG (DAB) MODULE Removal 1. Disconnect battery and wait for 2 minutes. 2. Rotate steering wheel in 90 degree clockwise direction, insert screw driver from bottom cover to disengage DAB snap, rotate steering wheel in 90 degree anticlockwise direction, insert screw driver from bottom cover to disengage DAB 2 nd snap. 3. Disconnect electrical connectors of air bag inflator and horn from DAB after removal of the plastic clamp provided for the inflator connector 4. Carefully take out DAB.