SAFARI STORME MY14

ELECTRICAL 84 REMOVAL: 1.Remove the steering wheel ( For procedure refer steering section ). 2.Loosen three fixing screws of assy nacelle lower and assy nacelle upper, located in bottom side of assy nacelle lower. 3.Dismantle both nacelle from snap fitting and take out the both nacelle. 4.Disconnect the all connectors of combi-switch, & clock spring. 5.Remove the clock spring ( if fitted ) (For procedures refer SRS section ). 6.Loosen one mounting screw of combi-switch and pull out the combi-switch assembly. INSPECTION: 1. Disconnect the Combi - switch connectors. 2. Using multimeter, check the continuity or resistance values between the terminals according to switch position. If continuity not found, replace the effective stalk. REFITMENT: 1.Insert the combi-switch assembly into the steering column and aligned the location lug with the key slot provided on steering column. 2.Tighten the one mounting screw of combi-switch Tightening torque for the screw – 0.18 Kgm. NOTE:  There should not be any lateral movement.  There should not be any damage or deformation observed on the combi switch housing and the mounting screw. 3.Fit the clock spring ( If fitted ) ( For procedure refer SRS section ). 4.Connect all the connectors of combi-switch, & clock spring. 5.Snap fit the assy lower nacelle and assy upper nacelle, and fit the three mounting screws in the assy nacelle lower. 6.Fit the steering wheel properly. ( For procedure refer steering section ).