SAFARI STORME MY14

PROPELLER SHAFT 18 3. Remove rear spacer ring with Puller (Part No. 312 589 25 33) pull out centre bearing assembly from propeller shaft. Remove front spacer ring. INSPECTION OF CENTRE BEARING Clean all parts thoroughly. NOTE Do not apply solvent in bearing assembly and rubber housing. Check the following 1. Check the condition of splines and threads on shaft. 2. Check the slip spline for excessive radial movement. Insert the slip yoke into the tube shaft and check the radial and lateral looseness between the slip yoke and the tube shaft. The lateral displacement should not exceed 0.15mm and radial displacement should not exceed 0.18mm. 3. Check the condition of splines and holes on coupling flange. 4. Check the condition of rubber housing. Replace with new one if necessary. 5. Check the condition of centre bearing bracket bearing surface and mounting holes. 6. Check the condition of clamping strap for any damage especially at crimping portion.