SAFARI STORME MY14

PROPELLER SHAFT 10 B. PROPELLER SHAFT (4X4) REAR PROPELLER SHAFT REMOVAL 1. Loosen and remove the front mounting bolts of bearing strap which holds the propeller shaft with the Transfer case. Take out the front end of rear propeller shaft from transfer case. 2. Loosen and remove the mounting nuts (Nos.4) of bearing strap from rear axle end. Take out the rear end of propeller shaft from rear axle along with vibration damper. FITMENT Before fitment ensure that 1. Splines should slide freely with slight drag from splines shaft seal. Cross should flex and be free from excessive bind. NOTE A slight drag is the most desirable condition on a new cross and bearing kit. Excessive looseness is not desirable and will result in an unbalanced propeller shaft. 2. Mounting Flange should be free from burrs, paint and foreign substances which would not allow proper seating at assembly. 3. While installing and servicing system balanced assemblies, the following care should be taken: ! CAUTION  End yokes must not be rotated from their original position during reassembly.  Self locking bolts used with bearing straps should not be reused . !! WARNING 1. Do not go under the vehicle when the engine is running. 2. Install a support strap when servicing propeller shaft to prevent personal injury. !! WARNING A serious or fatal injury can occur due to: 1. Lack of proper training. 2. Fail to follow procedures. 3. If proper tools and equipment are not in use. 4. If assembly of propeller shaft components is improper. 5. Use of incomplete propeller shaft components assembly. 6. Use of worn out or damaged propeller shaft components. 7. To avoid this get proper training, learn and follow safe operating procedures, use proper tools and safety equipments, use proper components in good condition. For further installation follow the reverse order of removal procedure