SAFARI STORME MY14

Rear Axle 20 With force still applied, set indicator to 0.00. Force differential assembly to the extreme end in opposite direction. Repeat above steps until the same reading is obtained. Record reading in the format given as 'A'. Remove master bearing and set aside. Assemble ring gear to case. Note: Use new ring gear screws. Torque ring gear screws to specification. Assemble master differential dummy bearing on to case hubs. Place differential assembly into housing. Install dial gauge and locate tip of indicator on the surface of one of the ring gear screws. Force differential case assembly away from pinion gear. With force still applied set indicator at 0 (Zero). Force differential case assembly and ring gear to mesh with pinion gear. Rock the ring gear to allow teeth to mesh Repeat to obtain a stable reading. Record in given format as B. Remove indicator and master differential bearings. Install side bearing cone on hub off differential assy. And place bearing cup along with selected shim pack in between side bearing and carrier assy. 1. Dolly-pressing diff case bearing. Repeat this procedure for installation of shims / bearing cone on opposite side of differential case. Install spreader and dial indicator. Spread the carrier. Do not spread it over 0.58 mm. Remove dial indicator. Install differential case assembly into carrier with the help of mallet, Ensure Diff case shim (spacer bearing preload is behind the bearing cap).