SAFARI STORME MY14

Rear Axle 16 TABLE B Old Pinion Marking (English) New Pinion Marking(English) -10 -8 -5 -3 0 +3 +5 +8 +10 +10 +.20 +.18 +.15 +.13 +.10 +.07 +.05 +.02 0 +8 +.18 +.16 +.13 +.11 +.08 +.05 +.03 0 -.02 +5 +.15 +.13 +.10 +.08 +.05 +.02 0 -.03 -.05 +3 +.13 +.11 +.08 +.06 +.03 0 -.02 -.05 -.07 0 +.10 +.08 +.05 +.03 0 -.03 -.05 -.08 -10 -3 +.07 +.05 +.02 0 -.03 -.06 -.08 -11 -.13 -5 +.05 +.03 0 -.02 -.05 -.08 -10 -.13 -.15 -8 +.02 0 -.03 -.05 -.08 -11 -.13 -.16 -.18 -10 0 -.02 -.05 -.07 -10 -.13 -.15 -.18 -.20 3.6 ESTABLISHING PINION & GEAR DEPTH USING SERVICE TOOLS & GUAGES Pinion Position Shim Selection: Pinion position shim selection can also be done using a special tool, in the absence of removed ring/pinion gear. Install pinion height set master block over pinion inner bearing cup seat. Set the dial gauge to 0 (zero), on surface plate. Install dial gauge on pinion height gauge which is again a part of tool. Install pinion height set gauge with dial gauge on side bearing seats. Ensure that plunger of dial gauge touches top face of pinion height set master. Rock depth gauge. Record maximum reading on gauge needle. Let it be X' To calculate shim thickness procedure as follows: Shim thickness required = X - etched value on pinion (when etched POSITIVE) Shim thickness required = X + etched value on pinion (when etched NEGATIVE)