SAFARI STORME MY14

SUPPLEMENTARY RESTRAINT SYSTEM (SRS) 22 LOAD LIMITOR In high speed frontal crashes, passenger moves for- ward due to inertia at a very high speed. If the seat belt gets locked during such crashes it may cause injuries to the passenger as he is forcibly held by the seatbelt against the inertia force. Load limiters are provided to limit the seat belt loads to a pre-defined value. Load limiters are to be used only in airbag equipped vehicles. The load limiter fitted inside the retractor unit is basically a torsion bar. Whenever the belt load increases beyond the pre-defined limit, some length of the belt is released due to twisting of the torsion bar. The activation of the load limiter does not depend on signal from the ECU. ON VEHICLE REPAIR !! WARNING The system has back-up power for about 30 seconds after the battery is disconnected. Wait for at least ONE minute after disconnecting the battery before servicing the vehicle. REMOVAL 1. Disconnect battery connection. 2. Fold the front seat to have easy access for the belt removal. 3. Loosen and remove the lower mounting bolt of seat belt. 4. Remove “B” pillar trim. (For procedure refer “B” pillar trim removal process.) 5. Remove the RPLL mounting bolt 6. Disconnect the electrical connector of RPLL.