SAFARI

19 FRONT AXLE - 4 X 4 ASSEMBLY Install brake disc on a soft - jaw vise. Assemble the hub and brake disc and secure with five bolts and lock washer. Torque bolts to specified value. Assemble outer bearing cup using dolley to press cup in hub (outer) Pt. no. 2704 5890 3303. Fig. 17 Assemble inner bearing cup using dolley to press cup in hub (inner) Pt. no. 2704 5890 3304 Fig. 18 Pack the inner spindle and the outer bearings with specified grease. Mount the spindle suitably. Assemble spindle needle bearing using Dolley to press needle roller bearing spindle Pt. no. 2704 5890 3327. Drive the bearing until the tool bottom out against the spindle. Note : Make sure that the bearing number on the race are placed against the tool. Assemble the spindle to steering knuckle. Tighten the sin nuts to specified torque. Fig. 19 Assemble new hub seal. Assemble the bearing to the spindle using. Dolley to press bearing cone in spindle. Pt. no. 2704 5890 3320. Apply grease to bearing assembly to spindle, if required. Mount the hub and brake disc assembly suitably. Assemble the spindle assembly onto hub and brake disc assembly. Note : Small amount of rocking motion of steering knuckle may be required. Assemble the packed outer bearing onto spindle. Assemble inner wheel bearing adjusting nut. Note : Ensure that the lock pin is towards outside (tool side). Fig. 17 Fig. 18 Fig.19