SAFARI

30 TRANSFER CASE 14. BOLT 15. WIRING CLIP 16. IDENTIFICATIONTAG 17. COVER ASSY 26. MAGNET 27. SPEEDO GEAR 28. OIL SEAL 29. RETURN SPRING 38. RAIL SHAFT Install the cover into the transfer case as follows: Refer fig. 36 * Align the cover holes with the transfer case dowel pins * Align the cover bearings with output shafts. * Align the cover blind hole with rail shaft and make sure that return spring is not cocked Tighten nine bolts positioning identification tag and wiring clip Install the speedo gear over output shaft spline in the cover assembly Press the new oil seal into the cover assembly. The indication tag is attached to the transfer case at the location shown in the figure. The manufacturing details are stamped on the tag. This information is necessary for ordering replacement spare parts. Fig. 37. The identification tag explanation is given in general group. 91. SPEEDO ASSY 92. GEAR SPEEDO 93. SHAFT SPEEDO 94. SEAL 95. O RING 96. BODY SPEEDO 97. BOLT 111. TRANSFER CASE 13. MOTOR ASSY. 14. BOLT 15. WIRING CLIP 16. IDENTIFICATION TAG Fig. 36 Fig. 37