NEXON EV SERVICE MANUAL

SUSPENSION 42 15.Disconnect the bundy pipe/Hose from wheel cylinder. Remove bleed screw. Put rubber dust cap on to the bundy pipe to avoid brake fluid from spilling and contamination. 16.Remove the stub axle and back plate along with brake shoe assembly. 17. Remove the shock absorber lower bolts and coil springs. (Refer removal and refitment of shock absorber and coil springs) 18.Give Support to the stub axle from bottom side. 19. Loosen and remove the twist beam bracket bolts on both sides. 20. Lower the twist beam along with bracket 21.Remove the twist beam cross bolt on both sides. 22. Twist beam bush removal 23.Remove twist beam front pivot bush using special tools as shown in below arrangement. NOTE: • Apply soap water to the bush and the bore of twist beam assembly before installation. • Tightening of RTB on body to be done in preloading condition. No jacking to be done on beam, avoid oil based lubricant while pushing the bushes in eye