Background Image
Table of Contents Table of Contents
Previous Page  20 / 1119 Next Page
Information
Show Menu
Previous Page 20 / 1119 Next Page
Page Background

1.2L REVOTRON ENGINE

9

Improper Electrical supply at pump

connector

If electrical supply is in proper check

electrical system.

In adequate fuel pump pressure

IF fuel pump does not built pressure then

replace.

Incorrect

manifold

absolute

pressure (MAP) sensor signal

input.

Check for leakage at sensor.

Perform diagnostic test.

Engine

idles

erratically

Disconnected or leaking vacuum

line or vacuum leak at inlet

manifold.

Inspect

all

vacuum

lines

and

connections. Repair or replace as

necessary.

Faulty ETC unit.

Perform diagnostic test. Replace as

necessary.

Incorrect valve / ignition timing.

Check timing system components and

repair or replace as necessary.

Fuel filter if clogged.

Replace the fuel filter.

fuel lines are pinched or clogged

Correct the routine to avoid pinch, or

allow shop air to clear the clog in the fuel

lines.

Improper Electrical supply at pump

connector

If electrical supply is in proper check

electrical system.

In adequate fuel pump pressure

IF fuel pump does not built pressure then

replace.

Poor Engine Performance

Condition

Possible Cause

Remedy

Maximum RPM -low

Insufficient battery voltage/charge -

test battery and charging system.

Clean and tighten battery connections

Jump start engine.

Battery or charging system component

faulty. Replace as necessary.

Obstructed air filter or air inlet

Clean or replace air filter or inlet.

Improper grade or contaminated

fuel

Rush fuel system with fresh, clean, fuel

of the correct type. Replace fuel filter.

Faulty spark plugs, wires, or

ignition coil

Check ignition system components for

proper operation. Replace as necessary.

Malfunctioning

engine

management system component

Perform engine management system

diagnostic test as described in this

section of the manual.

Fuel filter if clogged.

Replace the fuel filter.

fuel lines are pinched or clogged

Correct the routine to avoid pinch, or

allow shop air to clear the clog in the fuel

lines.

Improper Electrical supply at pump

connector

If electrical supply is in proper check

electrical system.

In adequate fuel pump pressure

IF fuel pump does not built pressure then

replace.