Background Image
Table of Contents Table of Contents
Previous Page  886 / 924 Next Page
Information
Show Menu
Previous Page 886 / 924 Next Page
Page Background

SUPPLEMENTARY RESTRAINT SYSTEM (SRS)

7

1.5. SRS POST ACCIDENT PROCEDURE:

A. The complete airbag system consists of

following components. Those cannot be

serviced/repaired,

hence

should

be

replaced

in

case

of

any

damage/deployment irrespective of ‘if

found ok’.

a) Driver airbag

b) Passenger airbag

c) Seat belt assembly

d) Front impact sensors

e) Wiring harnesses

f) SRS ECU

g) Clock spring

B. If Frontal Airbags, seat belt pretensioners

are deployed during collision, following

components must be replaced irrespective

of ‘if found ok’.

a) Driver airbag

b) Passenger airbag

c) Front Seat belt assembly RH & LH

d) Front Impact sensors -LH & RH

e) Cockpit (with PAB provision & wiring

harness)

f) Wiring harness

g) SRS ECU

h) Clock spring

E.

After any type of vehicle accident, thoroughly

inspect all the airbag system components for

any damage or deformation. Replace

components as required. Thorough inspection

of their mounting locations is also strongly

recommended after any accident.

F.

If any damage or deformation is observed on

any airbag system components, these

components

MUST be replaced

even if they

are not deployed/ fired in the accident and are

showing healthy status when checked.

G.

Special attention should be paid to mounting

surfaces and mounting brackets mainly for

SRS ECU, Front impact sensors and Side

impact sensors as they are extremely critical

for performance of the system. If these cannot

be repaired to their original condition, the

original panel(s)

MUST be replaced

.

H.

In case of damage to SRS wiring

harness/wires, they must not be repaired but

replaced.

I.

If steering wheel and steering column are

deformed or if the steering column is collapsed

in an accident replace these components.

J.

The accident Vehicle should be inspected to

identify component deformation or structural

deformations, damages for repair or

replacement. e.g. Vehicle front, side, rear

structure, seats, underbody components etc.

K.

Check for DTC’s using diagnostic tool and

troubleshoot to clear all the DTC’s detected.

!! WARNING

‘If the SRS warning indicator in the instrument

cluster illuminates continuously, it means there is

a malfunction in the system, vehicle needs to be

diagnosed then take the vehicle to nearest TATA

Authorized Service Center’.