Background Image
Table of Contents Table of Contents
Previous Page  59 / 1232 Next Page
Information
Show Menu
Previous Page 59 / 1232 Next Page
Page Background

Revotron 1.2T

12

2. Engine Idle Problems

Condition

Possible Cause

Remedy

Engine Starts but does not idle

Faulty ETC unit.

Perform Diagnosis test. Replace

as necessary.

Clogged or faulty fuel regulator

or pump.

Check fuel system components,

repair or replace as necessary.

Incorrect manifold absolute

pressure (MAP) sensor signal

input.

Check for leakage at sensor.

Perform diagnostic test.

Engine idles erratically

Disconnected

or

leaking

vacuum line or vacuum leak at

inlet manifold.

Inspect all vacuum lines and

connections. Repair or replace as

necessary.

Faulty ETC unit.

Perform diagnostic test. Replace

as necessary.

Incorrect valve / ignition timing.

Check timing system components

and repair or replace as

necessary.

Clogged or faulty fuel regulator

or pump.

Check fuel system components,

Repair or replace as necessary.

Improper firing order.

Check ignition system and fuel.

3. Poor Engine Performance

Condition

Possible Cause

Remedy

Maximum RPM -low

Insufficient

battery

voltage/charge - test battery

and charging system.

Clean

and

tighten

battery

connections

Jump start engine.

Battery or charging system

component faulty. Replace as

necessary.

Obstructed air filter or air inlet

Clean or replace air filter or inlet.

Improper

grade

or

contaminated fuel

Rush fuel system with fresh,

clean, fuel of the correct type.

Replace fuel filter.

Faulty spark plugs, wires, or

ignition coil

Check

ignition

system

components for proper operation.

Replace as necessary.

Malfunctioning

engine

management

system

component

Perform engine management

system

diagnostic

test

as

described in this section of the

manual.

Clogged or faulty fuel filter,

fuel regulator, fuel line, or fuel

pump

Check fuel system components,

repair or replace as necessary.

Incorrect crank angle signal

Check sensor gap and adjust to

1.4 ± 0.4mm

Clogged

or

faulty

fuel

injector(s)

Check fuel injector operation.

Replace as necessary.

Improper firing order

Check ignition system and fuel

injector connections. Rectify as

necessary.