BRAKES 51 6. Adjust the parking brake cable slackness as per the procedure given. NOTE: Refer parking brake adjustment procedure (point 14.8). 7. Tighten the parking brake slackness adjustment nut located inside the console. 8. Reconnect the electrical connections to the parking brake switch assembly and confirm that the parking brake lamp becomes “ON” when parking brake lever is at first notch. 9. Fix the Console Rear cover. 14.8 PARKING BRAKE CABLE ADJUSTMENT PROCEDURE (For HIGH & LOW END) 1. Before parking brake cable slackness adjustment, confirm the following conditions. 2. Bleeding should be completed. (i.e. there should not be air trapped in the brake system). 3. Confirm pedal travel by depressing the brake pedal for few times. 4. Check the lining condition of the rear brake; it should not have been worn out beyond limit. After confirming all the above points, start adjusting the parking brake lever stroke by either loosening or tightening the self-locking slackness adjustment nut. For details, refer maintenance section. 5. Keep Parking brake lever in 0th notch and tighten the parking brake cable adjustment nut through Console Rear cover opening. 6. Pull Parking brake lever fully and release it for 5 times. 7. If notch position is 4 to 5 then hand brake setting is OK. 8. If notch position is above 5, then tighten the hand brake adjustment nut for getting final notch position. 9. If notch position is below 4, then loosen the nut for getting final notch position.
RkJQdWJsaXNoZXIy MTIwNTUz