SUSPENSION 26 2. Tighten all bolts and nuts to specified torque mention in Torque table. 3. Apply ADH thread locker wicking grade ANABOND 124 at nut end and bolt thread. Ensure that the threads are free from oil/grease. CAUTION: 1. Ensure that brake hose does not damage during installation. 2. Strut having the same color code mark on the spring should be assembled on the left hand and right hand side. 9.2 ON BENCH FRONT STRUT REMOVAL AND ASSEMBLY REMOVAL Compress the spring with spring Compression tool part No. 8855 2702 0040 until the spring tension is released (i.e. becomes free in its seating place).Hold the piston rod by Allen key (A/F: 6 mm) to stop piston rod rotation during loosening of nut. Unscrew nut (1) and dismantle the parts. ASSEMBLY Check the condition of the components before assembly and replace if found damage. 1. Compress the spring with spring compression tool part No. 8855 2702 0040 to reduce length as done during disassembly. 2. Insert the compressed spring on the strut (ensure that the spring end is located at Lug in spring seat lower). 3. Pull strut piston rod up to full extended length. 4. Insert bump stopper.
RkJQdWJsaXNoZXIy MTIwNTUz