TRANSAXLE - TA65 Star 24 12. Connect clutch release cable to clutch release lever and adjust (see Clutch group for cable adjustment procedure). Route the harness carefully under the lever. 13. Fix starter motor. 14. Align and insert both LH and RH sides drive shaft assemblies into transaxle carefully. 15. Tighten Drive shaft Lock Nut. CARE SHOULD BE TAKEN NOT TO DAMAGE DRIVESHAFT OIL SEAL AND ITS BOOTS (DO NOT USE HAMMER). Ensure that splined end of plunge joint is inserted fully in differential gear. 16. Assemble ball joints on lower link (both RH and LH). 17. Connect ball joint (steering rack) on steering knuckle. 18. Connect Speedo-cable and vehicle speed sensor. 19. Mount Brake caliper on brake disc and tighten the mountings on brake caliper. 20. Connect electrical connection on starter motor. 21. Position and Tighten Fuse Box. 22. Fit wheels and hand tighten the bolts and lower the vehicle from the two post lift. 23. Tighten wheel mounting bolts to specified torque. 24. Connect the battery negative terminal.
RkJQdWJsaXNoZXIy MTIwNTUz