Load limiters are provided to limit the seat belt loads to a pre-defined value. Load limiters are to be used only in airbag equipped vehicles. The load limiter fitted inside the retractor unit is basically a torsion bar. Whenever the belt load increases beyond the pre-defined limit, some length of the belt is released due to twisting of the torsion bar. The activation of the load limiter does not depend on signal from the ECU. ON VEHICLE REPAIR REMOVAL 1. Disconnect the battery connection. 2. Fold the front row seat. 3. Remove lower “B” pillar trim. (For procedure, refer Body section). 4. Open the top mounting bolts cap. 5. Remove the top anchorage bolt. WARNING Do not attempt to repair, open or apply power (Multimeter) to the RPLL terminals. CAUTION Disconnect the battery negative lead. SRS 27
RkJQdWJsaXNoZXIy MTIwNTUz