Remove the Hose Pipe Charger out to Motor 16. Inlet and drain coolant. Collect the refrigerant using standard 17. recovering equipment. Remove the compressor. (Refer compressor 18. removal section for removal process.) Support Motor E-Drive from Bottom side using 19. special Tool. Loosen and remove the mounting bolts of 20. motor bracket support. Loosen and remove the mounting bolts of 21. motor bracket support. Loosen and remove the mounting bolt on C- 22. Mount Bracket. Use special tool to keep E drive safely down 23. take it out. Fitment Follow reverse procedure for assembly. 1. After connecting the LV battery, Start the vehicle and after 5 minutes if the coolant level drops below the max level then top up the coolant till max level. 2. Connect the diagnostic tool to OBD connector. 3. Turn the IGN ON. NOTE After filling the coolant, the coolant pump can be run through the service tool for the deaeration of coolant circuit. Or the vehicle can be cranked to run the pump, because in vehicle cranked state the pump operation starts in default speed which will in turn deaerate the circuit. HIGH VOLTAGE ELECTRICAL SYSTEM (HV) 67
RkJQdWJsaXNoZXIy MTIwNTUz