3. TIGHTENING TORQUES *MARKED BOLTS TO BE TIGHTEN IN ECIE / PRE-LOAD CONDITIONS. NOTE Unless otherwise specified, no oil/lubricant / thread locker allowed on fastener, fastener bearing surface or surface where the fastener will sit while assembly. All self-locking type fasteners not to be re-used once joint is dismantled. Use of appropriate thread locker has been mentioned at required location. Carefully go through the service manual for the same. Before reassembly inspect the mating surfaces for any defects/deposits/burr/debris/deadner. Similary inspect the nut and bolt thead surfaces also. To be corrected/removed for a sound joint. Use only calibrated torque wrenches. SR. NO DESCRIPTION FASTNER TYPE TORQUE VALUE (KGM) LOCATION 1 Front strut mounting on knuckle M12X30 12 ± 0.6 2 Strut top mounting NYLOC NUT M8 2.3 ±0.1 3 Driveshaft lock nut M22X1.5 24.5 ± 1.5 SUSPENSION (LR) 6
RkJQdWJsaXNoZXIy MTIwNTUz