COCKPIT REMOVAL (COMPLETE ASSY) • REMOVAL 1. Remove Door (For procedure refer Door removal process in Door section.) 2. Remove two dashboard mounting bolts on LH & RH side as shown in figure. 3. Remove steering wheel with Driver air bag (if applicable) (For procedure refer steering wheel removal process in steering section.) 4. Remove End Cap RH and pull out Driver lower panel. Detached Nacelle Upper assembly from Nacelle Lower & Cluster Cover (Gap Hider which is a part of Nacelle Upper is attached to Cluster Cover by rib locks) 5. Remove Nacelle Lower (by removing three screws with steering column) 6. Remove nacelle Assembly. (For removal refer steering column removal process in steering section.) 7. Remove combination switch assembly and ignition switch assembly (For procedure refers combination switch and ignition switch removal process in Electrical section.) 8. Remove two upper steering column and lower steering column mounting nuts. 9. Remove music system (If applicable). (For procedure refer music system removal process in Electrical section). Remove floor console assembly. (For 10. procedure refer floor console removal process). Pull out at end cover LH side 11. Remove ‘A’ pillar upper and lower trim. (For 12. procedure refer ‘A’ pillar trim removal process.) BODY 16
RkJQdWJsaXNoZXIy MTIwNTUz