FATC 12 G. FRESH AIR / RECIRCULATION : When the recirculation Touch Button or LED is switched ‘ON’, air from the vehicle’s interior is sent throughout the system. When the recirculation button is switched ‘OFF’, air is brought in from outside of the vehicle (fresh mode). Whenever discomfort is felt, switch to fresh air mode. NOTE The outside air intakes for the climate control systems are at the base of windscreen. Keep this area clear from leaves and other debris. The system should be used with recirculation air mode for faster heat up and cool down, however keeping the system in recirculation mode, particularly with AC OFF, can cause the windows fog up. H. AIR DISTRIBUTION (MODE) : In AUTO mode, the FATC system will regulate the mode automatically. However, user override is possible with the use of MODE button to select the desired airflow mode. Each time you press the MODE button, the display shows the mode selected. Directs air through the center and side air vents Directs air through the center, side and foot well vents Directs air through the foot well air vents Directs air through the defroster & foot well vents (De-fault fresh air mode) Directs air through the defroster vents (Default fresh air mode) I. AUTO ON SELECTION To put the automatic climate control in fully automatic mode: A. Press the ‘AUTO’switch. B. Set the desired temperature by pushing temperature control switch. The display will show all the functions during ‘AUTO’ mode. C. The system automatically selects the proper mix of conditioned and /or heated air that will, as quickly as possible, raise or lower the interior temperature to your preference. D. When you set the temperature to it lower limit (-) or upper limit (+), the system runs at full cooling or heating only. It does not regulate the interior temperature. Semi-automatic Operation You can manually select various functions of the climate control system when it is in fully automatic mode. All other features remain automatically controlled. Making any manual selection causes the word ‘AUTO’ in the display to go OFF and overridden setting is displayed. System will remain in semiautomatic mode till ‘AUTO’ is re-pressed. NOTE In ‘AUTO’ mode, the FATC system will regulate the blower speed automatically. J. TEMPERATURE CONTROL KNOB Uplifting the temperature control knob increases the temperature of the air. The desired temperature will be increased by steps of 0.5ºC. User can select temperature range from 18ºC to 30ºC. Whereas depressing decreases the temperature. When you set the temperature to its lower limit (-) or its upper limit (+), the system runs at full cooling or heating only. It does not regulate the interior temperature.
RkJQdWJsaXNoZXIy MTIwNTUz