INSTALLATION 1. Align the EPB motor shaft in the spindle (B) & mount the motor. 2. Tighten the EPB motor mounting screw (A). 3. Connect the electrical connector of EPB motor. 4. Fit the wheels and tighten wheel mounting nuts to specified torque. H. REAR WHEEL SPEED SENSOR REMOVAL 1. Position the vehicle on two-post lift. 2. Disconnect electrical connector of wheel speed sensor. 3. Remove sensor-mounting screw and remove the wheel speed sensor. INSTALLATION 1. Clean speed sensor and its mounting surface. 2. Route the cable properly. Install the wiring harness connector with wheel 3. speed sensor cable. 4. Make sure that the sensor cable connector is fully seated and locked into vehicle wiring harness connector. WARNING Take proper precaution while disconnecting the wheel speed sensor from vehicle wiring harness, by not damaging pins of connector. NOTE Before replacing wheel speed sensor, carry out diagnosis of wheel speed sensor. (Refer Troubleshooting and Diagnosis. BRAKES_LR 50
RkJQdWJsaXNoZXIy MTIwNTUz