Don’t use hammer or rod to remove EPAS 16. I/Shaft. DO’S 1. Lift steering gear by holding mountings / body / cylinder only. 2. Store / transport steering gear resting on body / cylinder only. 3. Use steering gears on ‘first in first out’ basis. 4. If any steering gear is dropped, inspect for damage before using. 5. If any bellow is found damaged, replace it immediately with a good part & with proper position of clips 6. If any bellow clip is found missing, do not use the defective steering gear. Instead use another new steering gear 7. If the steering gear is off the vehicle, all ports should be covered with protective plugs to avoid contamination. 8. If any bellow is found damaged, replace it immediately with a good part & with proper position of clips. 9. If any bellow clip is found missing, do not use the defective steering gear. Instead use another new steering gear. If the steering gear is off the vehicle, all ports 10. should be covered with protective plugs to avoid contamination. Do use steering puller to avoid capsule 11. collapse & column serration damage. Image for illustration purpose only Do use proper packed parts & ensure for 12. collapse marking not disturbed. Handle part with care and not to fall down the 13. parts. Always keep your hand on motor while 14. removing from CCB. NOTE Bellow is a seal. Do not use sharp tools near • bellows if it can damage bellows. CAUTION Damaged bellow or absence of clip can • cause water ingress and subsequent failure of Power steering. STEERING_MANDO 24
RkJQdWJsaXNoZXIy MTIwNTUz