HV ELECTRICAL SYSTEM_MR & LR 14 H. WASHING INSTRUCTIONS HIGH-PRESSURE WASHING INSRTUCTION WARNING Do not direct high-pressure washer fluid/ water jets (Pressure above 0.5 bar) at electrical devices and connecter during washing. This is to prevent malfunction / failure of electrical system due to water ingress. High-pressure washing is not allowed in the motor bay and on the battery connectors. When using high-pressure washers, make sure to maintain sufficient distance from the vehicle. Insufficient clearance or excessive pressure can lead to component damage or water penetration. Do not spray the camera, sensors or its surrounding area directly with a high-pressure washer. Shock from high-pressure water may cause the device to not operate normally. Do not bring the nozzle tip close to boots (rubber or plastic covers) or connectors, as they may be damage if they are exposed to high-pressure water. Pressure washing is not recommended at under hood area (Bonnet), under body & near rear LH.wheel arch. (Images for Illustration only) WASHING PROCEDURE Following these tips while washing your vehicle. 1. Always wash your vehicle in shade and the surface is at room temperature. 2. Wash with mild vehicle wash soap like ‘Car Shampoo’ and use a soft bristle brush, sponge or soft cloth and rinse it frequently while washing to avoid scratches. 3. To avoid scratches, please wear soft gloves. Remove finger rings, nails, wristwatch while washing. 4. To remove stubborn stains and contaminant like tar, use turpentine or cleaners like ‘Stain remover’, which are safe for, paint surfaces. 5. Avoid substances like petrol, diesel, kerosene, benzene, thinner, acids or other solvents that cause damage to paint. 6. Dry your vehicle thoroughly to prevent any damp spots. 7. Rinse all surfaces thoroughly to prevent any traces of soap and other cleaners as this may lead to the formation of stains on the painted surface later.
RkJQdWJsaXNoZXIy MTIwNTUz