H. DO’S AND DON’T DO’S: 1. Please ensure that the phone is compatible to the charging standard “Qi”. 2. If there is any metallic object between smartphone and wireless charger pad, immediately remove smart phone and metallic object after it has completely cooled down. Once any metallic object is detected on wireless charger post charging it displays its warning message on Infotainment unit, first remove smart phone then remove foreign object from the charging pad and place the smart phone again on charging pad. 3. In case of water/Liquid spillage on charging pad, dry out the pad surface area properly & clean the ECU surface area by removing Antiskid mat. Do not charge the smart phone until surface is completely dry. 4. The Phone charging status is information by phone and not charger. 5. Wireless charger works on principle of magnetic induction, i.e. it converts electrical energy into magnetic energy to transfer energy from charging pad to phone. Please maintain safe distance from the charger most of the time as it may cause irritation to sensory organs or active implants if implemented in the body. Please consult medical specialist in case implant organ in the body of the user. 6. Place the smart phone on the centre of the charging pad for effective charging with best results. 7. It is recommended to turn on Engine while charging phone on wireless charger to avoid vehicle battery drain. 8. User shall clean charging pad/mat periodically to avoid dust accumulation. 9. It is recommended to keep Vehicle AC at least 23 Deg Cel with Fan speed above 2 level as cool environment support efficient charging of the phone. It is recommended to keep mobile phone at 10. centre of charging pad for effective charging. In case small phone kept at corner do not start charging or foreign object detection message pop-up, please move phone to centre of pad. Always use TATA MOTOR LIMITED approved 11. charging pad for efficient charging. DON’TS: 1. Do not use metallic smart phone covers as it would halt the wireless charging function. The wireless charging may not function properly when there is a heavy & thick (more than 1 mm thick) accessory cover on the smart phone. 2. Do not place smart phone up-side down (screen face) on charging pad or do not misalign mobile phone on charging pad in such case smartphone will not charge. 3. During phone charging, the wireless charger and phone may become warm. In this case, charging will stop due to phone’s internal protection function. Charging may resume after phone cools down. 4. Please do not put any liquid (e.g. water, cold drink, and sanitizer), dust particles or flammable object on anti-skid mat. 5. Do not cover the wireless charger with a cloth or other object while charging. It may heat up the device and reduce the charging efficiency. 6. Do not disassemble, modify or remove the wireless charger. Also do not apply force or impact to the wireless charger. WARNING If any metallic object such as coin/keys are located between wireless charging pad and phone back cover, the charging may get disrupted. Also, this may results in heat up of metallic objects. Low Voltage Electrical System (LV) 211
RkJQdWJsaXNoZXIy MTIwNTUz