3. Transfer approximately half of the grease from the service kit into the seal and half grease into the tripot housing. Slide the housing over the spider assembly on the shaft. Engage the tripot seal with the tripot outer. Important: The end of the tripot seal must be next to the seal stop on the housing. 4. Slide the tripot seal smaller end to the corresponding groove on the axle shaft and crimp the small seal retaining clamp (new one) using pincer crimping tool) and maintain max 2.6 mm. ear gap as shown below. (Spider Assembly at approximately middle of the tripot bowl). 5. Slide the new large seal retaining clamp over the housing in the free condition of the boot and housing Insert the swage tool part no: 2779 5890 2001 over the clamp. 6. Align the seal bigger diameter on the housing and position the big seal retaining clamp in its place and swage the large seal-retaining clamp using spanner Please tighten alternatively between two bolts (i.e. don’t tighten one bolt alone completely at a time). DRIVESHAFT DCT 21
RkJQdWJsaXNoZXIy MTIwNTUz