4. Place the lay shaft assembly and input shaft assembly together along with shifter rail assembly. 5. Fix the reverse gear assembly on the rearhousing half into the seat of reverse idler gear. Also fix the reverse lever bracket Assy. 6. Apply liquid gasket (Anabond 90 or 3 bond 12S00) with proper bead size on front half / interface. 7. Fix the housing (rear half) and tighten the flanged mounting bolts to specified torque. 8. Assemble three Hex FL Bolt M8X45.from inside from front housing half. 9. Assemble the housing (rear half) on lay shaft input shaft and shifter shaft and tap it gently and uniformly so that it gets located on lay shaft and input shaft bearing then place snap ring as shown NOTE Clean the front half and rear half interfaces/ • so that no cured and dried liquid gasket remained are left on the machined surfaces. Transaxle AMT 62
RkJQdWJsaXNoZXIy MTIwNTUz