Remove pre silencer Assy with pipe, front & 18. outlet pipe. Remove 3 allen bolt of intermediate shaft & 19. take out Drive shaft from driver side. Remove Drive shaft from co-driver side. 20. Remove heat shield of starter motor. 21. Remove electrical connection & its three 22. mountings from starter motor & take out the same. Give support from bottom side of Engine 23. Assembly. Loosen mounting bolts of clutch housing. 24. Remove fuel line supporting bracket from 25. clutch housing. Disconnect high-pressure hose assy. from 26. clutch release lever. NOTE Care should be taken not to damage • driveshaft oil seal and its boots (do not use hammer). CAUTION Do not pull drive shaft excessively as the • plunge joint will come out of housing and damage the boot Pry. Plunge joint housing for taking out joint out of splines. Do not place the CV drive shaft on rough / uncleaned surfaces. This might damage the drive shaft boot. Transaxle AMT 38
RkJQdWJsaXNoZXIy MTIwNTUz