Remove Drive shaft from co-driver side. 22. Remove Exhaust Front pipe mounting Bracket 23. on silencer support assembly to make accessibility for Hex Flange bolt on gear box. Give support from bottom side of Engine 24. Assembly. Loosen mounting bolts of clutch housing. 25. Remove fuel line supporting bracket from 26. clutch housing. Disconnect high-pressure hose assy. from 27. clutch release lever. Remove C-Bracket mountings from Subframe 28. assembly & Gear box also take out C-mounting bracket. Loosen the B- mountings 29. NOTE Care should be taken not to damage • driveshaft oil seal and its boots (do not use hammer). CAUTION Do not pull drive shaft excessively as the • plunge joint will come out of housing and damage the boot Pry. Plunge joint housing for taking out joint out of splines. Do not place the CV drive shaft on rough / uncleaned surfaces. This might damage the drive shaft boot. Transaxle AMT 34
RkJQdWJsaXNoZXIy MTIwNTUz