8. PRECAUTION FOR SAC ASSEMBLY Use only paired Clutch Disc & SAC set for assembly Don´t mix the disc from SAC-Set 1 to other SACSets 2, 3, 4... The Release load is adjusted with same set of SAC and disc. You can recognize that a disc was measured with a SAC because of the same serial number. Ensure same serial no. marking on SAC cover assembly & Clutch Disc. SAC Cover Assembly Clutch Disc Assembly SAC should be assembled with counter load only (i.e. without releasing the clutch) Don’t engage or disengage a clutch cover without having a disc under the pressure plate. SAC will adjust irregularly and produces unpredictable. Release load and Clamp load and therefore Pedal load is also unpredictable. Adjusting ring is inside cover notches, SAC is ok. Adjusting ring is outside cover notches, SAC is not ok Don’t release SAC without a clutch disc under pressure plate & unless the SAC is properly screwed to flywheel. Replacement of the clutch should be as a set only. Do not replace individual clutch disc or SAC. In field strictly follow the procedure as mentioned in service manual Ensure marking position on adjusting ring, if unfortunately a SAC adjust during mounting process, change the whole set. Ensure that the clutch facing material is not contaminated with oil or grease as this shall result in clutch slipping. Do not use any screw driver or other type of steel material to rewind the adjuster ring. You might damage the mechanism. CLUTCH_MT_AMT 19
RkJQdWJsaXNoZXIy MTIwNTUz