Give support from bottom side of Engine 20. Assembly Remove fuel line supporting bracket from 21. clutch housing. Disconnect high-pressure hose assy. from 22. clutch release lever. Disconnect ‘C’ mount bracket bolt. 23. Loosen and remove B Mount Bracket. With 24. rubber pad. Remove clutch housing mounting bolts. 25. Finally take out Gear box Assembly from 26. vehicle. INSTALLATION: Follow the reverse procedure of Assembly of Transaxle on Vehicle. NOTE Care should be taken not to damage • driveshaft oil seal and its boots (do not use hammer). CAUTION not pull drive shaft excessively as the plunge • joint will come out of housing and damage the boot Pry. Plunge joint housing for taking out joint out of splines. Do not place the CV drive shaft on rough / uncleaned surfaces. This might damage the drive shaft boot. TRANSAXLE (TA6300) 32
RkJQdWJsaXNoZXIy MTIwNTUz