H. PARKING BRAKE CABLE ADJUSTMENT Keep Parking brake lever in 0th notch and 1. tighten the parking brake cable adjustment nut through parking adjustment cover of center console. 2. Pull Parking brake lever fully and release it for 5 times. 3. If notch position is 3 to 4 then hand brake setting is OK. 4. If notch position is above 4 then tighten the hand brake adjustment nut for getting final notch position. 5. If notch position is below 3 then loosen the nut for getting final notch position. REMOVAL AND REFITMENT OF ABS ECU / I. HCU Following precautions should be carried while working on ABS. 1. Before undertaking any electric arc welding work, disconnect the ABS ECU’s connector. 2. During paintwork operations or major repair work, which are likely to subjected to higher temperature (above 85° C), The HCU must be removed. 3. Before removing the ECU, the battery must be disconnected. 4. Terminals must be fully tightened while installing battery. 5. Electrical wiring not to be repaired (should be replaced) REMOVAL 1. Turn OFF the ignition switch and disconnect battery. 2.Disconnect ABS ECU wiring harness connector. (i) Press the unlock button and remove the lever from the lock and move towards unlocking position. (ii) Lock the lever to it is unlock position by pressing the lever till the Click sound is heard and remove the connector from ABS ECU. NOTE Refer steps (i) and (ii) to disconnect ABS • ECU Connector. BRAKE_DIESEL 55
RkJQdWJsaXNoZXIy MTIwNTUz