1.2L REVOTRON TWIN CYLINDER CNG ENGINE 94 5. Canister Canister made of high grade Nylon, containing special dust free activated carbon is used to adsorb fuel vapours. The lower end of the canister is open to atmosphere for ventilation. The end is not really open but there is foam filter. The purpose of the bottom filter is to protect the canister from dust and dirt during operation. When the engine is inoperative (i.e. while parked) fuel vapours generated inside the fuel tank due to fuel volatility are absorbed and stored in the canister through tank pressure valve. When the engine is running, the fuel vapours absorbed in the canister are purged into intake manifold through canister purge valve operated by ECU. The purging takes place due to air drawn through the canister because of pressure differential between manifold vacuum and atmosphere. 6. Canister Purge Valve The canister purge valve is controlled by engine management system (EMS). The purging of canister takes place because of pressure differential between manifold vacuum and atmosphere. Fuel vapours are drawn into the intake manifold through canister purge valve operated by ECU. Inspection: 1. With ignition switch OFF, disconnect connectors from canister purge valve. 2. Check resistance between two terminals of canister purge valve. Resistance 26 + 4 ohm at 200C. If resistance is as specified, proceed to next operation, check. If not, replace. 3. Blow air into hose removed from T connector. 4. Verify that no air flows through the valve when the engine is stopped with purge valve connectors disconnected. 5. Air will pass through freely when the 12V battery voltage is applied to valve connector. It indicates that the valve is functioning properly. If no air flows, replace the valve. 6. Reinstall valve connector. 7. Reconnect vacuum hoses. Warning: Do not suck air through purge valve. Fuel vapours inside valve is harmful. 7. Fuel Filter (If Applicable) The Fuel Filter is a part of the filtration system. The fuel filter is located under the body near the fuel tank along the pipe carrying the fuel to fuel rail, It is made up of an outer case and an integral mount that holds a filter element with high filtering capacity. It filters the fuel being deliver under pressure by the fuel pump. This is essential for ensuring fuel injection operation since the injector is extremely sensitive to foreign particles in the supply circuit. Since it cannot be disassembled, it must be replaced as an assembly at the recommended intervals.
RkJQdWJsaXNoZXIy MTIwNTUz