If the gauge will enter the gap, additional • tightening is required. REASSEMBLY OF HP PIPE REMOVED FROM VEHICLE 1.We can disassemble and reassemble swagelock tube fittings many times. 2. In case any leakage (major/minor) found disconnect the tube from fitting, insert tubing with pre-swaged ferrules into the fitting body until the front ferrule seats. 3. Rotate the nut with a wrench to the previously pulled- up position, at this point, a significant increase in resistance will be encountered. 4. Tighten slightly with wrench. Ensure to match the marking on coupling nut and adopter (marking done before removal of joint from vehicle) then apply additional torque of 1/4th turn beyond initial marking. T. FUEL FILLER BOWL ASSEMBLY IN CASE OF NEW HP LINE FITMENT ON VEHICLE 1. 0pen the flap. Image is for reference purpose only. 2. Remove the fuel cap. Image is for reference purpose only. 3. Unhook X locator and remove the LID. 4. Unhook snaps and remove the plunger. 1.2L REVOTRON CNG PHASE-2 ENGINE 157
RkJQdWJsaXNoZXIy MTIwNTUz