BODY 16 F. INSPECTION OF SUN ROOF MOTOR AND CIRCUIT i) Voltage Check 1. Checking is done with sunroof connector still connected. 2. Check voltage using circuit tester. Terminal no. Wire color Signal spec Observation Condition Typical voltage 1 Ground for motor drive/ Signal All Approx. 0 V 3 ACC signal input ACTIVE Hi ・ON： Battery voltage ・OFF：OPEN ACC “OFF” Approx. 0 V ACC “ON” Approx. 12 V 4 S/R SW input C ACTIVE Low ・ON：GND ・OFF：OPEN ACC “ON” “C” switch: Pressed Approx. 0 V ACC “ON” “C” switch: Not Pressed Approx. 12 V 5 S/R SW input A ACTIVE Low ・ON：GND ・OFF：OPEN ACC “ON” “A” switch: Pressed Approx. 0 V ACC “ON” “A” switch: Not Pressed Approx. 12 V 6 Power supplyinput for control unit and motor. All Approx. 12 V 10 S/R SW input B ACTIVE Low ・ON：GND ・OFF：OPEN ACC “ON” “B” switch: Pressed Approx. 0 V ACC “ON” “B” switch: Not Pressed Approx. 12 V
RkJQdWJsaXNoZXIy MTIwNTUz