1.2L REVOTRON ENGINE 27 3. REPAIR AND INSPECTION DETAILS A. Canister Purge Valve Removal 1. Disconnect hose from canister purge valve to T connector. 2. Disconnect the hose from canister to purge valve from canister “purge” end. Inspection 1. With ignition switch OFF, disconnect connectors from canister purge valve. 2. Check resistance between two terminals of canister purge valve. Resistance 26 + 4 ohm at 20C. If resistance is as specified, proceed to next operation, check. If not, replace. 3. Blow air into hose removed from T connector. 4. Verify that no air flows through the valve when the engine is stopped with purge valve connectors disconnected. 5. Air will pass through freely when the 12V battery voltage is applied to valve connector. It indicates that the valve is functioning properly. If no air flows, replace the valve. 6. Reinstall valve connector. 7. Reconnect vacuum hoses. Warning Do not suck air through purge valve. Fuel vapours inside valve is harmful. B. Regular Maintenance: NOTE Use clip removal tool to remove clips, pin where as necessary to avoid the damage.
RkJQdWJsaXNoZXIy MTIwNTUz