HV ELECTRICAL SYSTEM 78 5. Remove the mounting nut and disconnect the Suction pipe of compressor to Heat Exchanger. 6. Remove the mounting nut and disconnect the Discharge pipe of compressor to front end module assy. 7. Loosen and remove the mounting cap screw of compressor and take it out. Fitment. Follow reverse procedure for assembly. Tighten the following fasteners to the recommended torque. i) Compressor mounting. ii) Refrigerant lines on compressor. NOTE • Always use compressor vibration dampers Do’s and Don'ts • Use only recommended refrigerant (R134a) and correct charge quantity (580 gms) in the AC system • Use only recommended lubricating oil for AC compressor (POE RL68H oil) • Ensure HV and LV connections of PTC heater are properly connected • Don’t remove connections of PTC heater when it is working • Always check coolant level in BCS tank • Avoid coolant leakage in BCS system • Do not change routing of coolant hoses. If hose get pinch then coolant flow will be restricted leading to battery over heat.
RkJQdWJsaXNoZXIy MTIwNTUz