BODY 70 INITIALIZING COMMAND PROCEDURE: To initialize the sliding sunroof, use the following procedure. 1. Turn ON the ignition 2. Sunroof to be in close position. Press the ‘sunroof close switch’ and hold it for 9 to 10 seconds. During this process, Sunroof goes to TILT position and makes clicking sound and stops at Tilt position. 3. Close Sunroof by again pressing close switch. 4. The Initializing command is complete, check if the Express open/close features are working. NOTE: If the initializing procedure is not completely performed, then it has to be run again from step 2. Self-learning the sunroof must be done after completion of Initializing the sunroof. Self-Learning is being done to learn the frictional forces of the system and to set the parameters in ECU as per current condition of the system SELF LEARNING COMMAND PROCEDURE: 1. Sliding sunroof shall be in open position within 4mm to 200mm from the front edge of cutout. 2. Close the sunroof fully by pressing ‘sunroof close switch’ and keep the switch pressed continuously. Do not release the switch and wait for following actions to perform. 3. Once Sliding sunroof reaches to closed position, will start its cycle after 8 sec, delay. Sunroof start to self-learning, run from close - tilt – close – partial open – close (10 seconds). Overall, 16 to18 seconds required to complete self-learning. 4. The Self learning command is complete. NOTE: Incase Sunroof Close switch is released in the middle of procedure, repeat from step 1.
RkJQdWJsaXNoZXIy MTIwNTUz