BODY 58 11. Unplug all the wiring harness connected to sunroof. Pull the connector in shown direction. Remove all the cables routed and clipped on to the sunroof. 12. Unplug all the drain hoses from 4 corners of the sunroof. Pull the hose in shown direction 13. Loosen all the mounting screws. 14. Remove all 10Nos. M6 Screws with washer and give support to Sunroof and take it out. NOTE Due to the weight of the sunroof assembly it is recommended that you use Jacks to support the sunroof assembly to avoid Twisting of guide rails during handling. D. SUNROOF FITMENT NOTE Due to the weight of the sunroof assembly it is recommended that you use Jacks to support the sunroof assembly to avoid Twisting of guide rails during handling. 1. Position the sunroof onto the mounting location. Push the connector in shown direction. 2. Attach all screws with washer. Do not tighten until the Guide rail aligned with the factory mounting points. 3. Once all fasteners are aligned and then start tightening securely. 4. Maintain tightening torque of 7±10% N-m 5. Plug all the wiring harness to the sunroof, Route all the cables and clip it on to the sunroof. 6. Plug all the drain hoses to all 4 corners of the sunroof. 7. Fix Beeding. 8. Fix A, B and C Pillar. 9. Fix All Grab Handles. 10. Connect electrical connection on microphone and sunroof switch. 11. Tighten 2 mounting screws on Roof console Housing. 12. Connect electrical connection on Roof Lamp and Tighten Roof Lamp. 13. Fix Sun visors. 14. Connect Battery –Ve Terminal.
RkJQdWJsaXNoZXIy MTIwNTUz