DRIVESHAFT 7 9. DISASSEMBLY PROCEDURE FOR DRIVE SHAFT 1. Hold the centre of the axle shaft in the vice and clean the shaft throughly, using cleaning solvent. Important: Do not damage the Booting surface of outer housing. 2. Remove the small Boot retaining clamp from the axle shaft with a side cutter or by tapping the clamp ear junction screw driver with rounded edge as marked in below figure. Discard the small retaining clamp. Important: The screw driver should not damage the Boot. 3. Remove the larger retaining clamp from the inboard joint by using the screw driver/plier. 4. Separate the housing assembly from the Boot at large diameter as shown in figure Slide the Boot away from the joint axle shaft. 5. Remove the spider assembly circlip by using plier and discard the retaining ring.
RkJQdWJsaXNoZXIy MTIwNTUz