Carefully remove the boot piston from the 6. caliper groove, ensure no dust and no damage in the boot groove while removing. Carefully remove the seal from the caliper 7. pot/cylinder groove, use proper tool. ASSEMBLY OF CALIPER TO THE CARRIER II. Insert seal into groove by rolling the index finger 1. over the seal. NOTE when apply air the piston moves out of the pot/cylinder, have a suitable stopper to avoid piston fall off, exercise more care, ensure there is no scratch, dent, damage and a spiral mark in the cylinder bore diameter while removing. NOTE Do not use any metal part with sharp edge to remove the boot piston and ensure dust prevention in the cylinder after removing. NOTE Do not use any metal part with sharp edge, ensure no cut mark, scratch in the seal groove, and ensure no damage in the seal groove. Drain the excess oils from the caliper and clean the caliper thoroughly only with isopropyl alcohol NOTE When assembling the seal, ensure in the cylinder groove is free from damage, the bore is smeared with oil. Apply (smear) enough grease to the seal before assembly, inspect the seal for no cut, tear damage and splashes, and after assembly ensure the seal has been seated well in the groove by rolling the index finger over the seal. BRAKES 41
RkJQdWJsaXNoZXIy MTIwNTUz