TIGHTENING TORQUES 2. NOTE Unless otherwise specified, no oil/lubricant/thread-locker/anti-rust allowed on fastener, fastener bearing • surface or surface where the fastener will sit while assembly. All self-locking type fasteners not to be reused once joint is dismantled. Use of appropriate thread locker has been mentioned at required locations. Carefully go through the • service manual for the same. Before reassembly, inspect the mating surfaces for any defects/deposits/burr/debries/deadner. Similarly • inspect the nut and bolt thread surfaces also. To be corrected/removed for a sound joint. Use only calibrated torque wrenches. • SR NO DESCRIPTION FASTNER TYPE TORQUE (KG-M) LOCATION FRONT SUSPENSION 1 ABS sensor mounting on knuckle Hex. Fl. scr M6X14 0.8 + 0.2 2 Antiroll bar mounting on BIW Hex. Fl. scr M10X1.25 4.5 ± 0.25* 3 Antiroll bar mounting on link NYLOC Nut M10 5.5 ± 0.3 FRONT & REAR SUSPENSION 2
RkJQdWJsaXNoZXIy MTIwNTUz