Remove two camshafts. 4. Remove ITG Bearing Cap Lower. 5. To dislocate cylinder head, use a soft mallet or 6. dead-blow hammer to break the head free from the block, if necessary. Place the cylinder head on the dismantling 7. table. REMOVAL OF CYLINDER HEAD SUB- VIII. ASSEMBLIES Remove the RFF along with Hydraulic Lash 1. Adjuster from the cylinder head as shown in below figure. Using Special Tool, to compress and remove 2. the valve spring lock halves. Remove the valve spring retainer. 3. CAUTION When removing the camshaft, use care to avoid damaging the bearing surfaces of the cylinder head and the camshaft. NOTE To avoid damage to valve tips, do not rotate the camshaft ENGINE 1.2L BSVI PHASE-2 128
RkJQdWJsaXNoZXIy MTIwNTUz