AMT KIT 26 G. POWER UNIT (PWU) BASE PLATE REMOVAL AND RE-FITMENT ON BENCH: - Removal: Disconnect all the connectors of the system wiring harness (DC Motor, Cultch Position Sensor and Transmission Control Unit) and threaded hole body. unit (MGA) first (refer the procedure. Mechatronic Gear Actuator Unit (MGA) Removal and ReFitment on Bench). Installation: fixture. In order to avoid O-rings damages, screw three rods Assemble the O-rings on the connectors. Mount the connectors with O-rings in their lu seats. Remove traces of oil from the Gea with gasket with care to avoid contamination from foreign materials (dust, metal burrs, etc.) or surface damages. Assemble the inserting the centering pins into the fixing body. gaske the threaded rods for reference and moving it parallel towards the mating surface. seats came in contact with O-rings, push it slowly, with appropriate load to complete the assembly. Unscrew the rods and screw the three screws the right torque 10 ± 1 Nm. Connect the connectors of the wiring harness Insert the plastic clip into its threaded hole on the connector of wiring harness on the DC Motor. Fi hydraulic circuit) and restore it after the purge procedure.
RkJQdWJsaXNoZXIy MTIwNTUz