AMT KIT 22 connections, sensors and gasket from accidental contact. from exposition to water, humidity or other foreign materials mission Control is water/humidity proof only when mounted on the system). ensure protection against the accidental fall of tools or other pieces, in particular on the connectors and sensors. Never use improper tool (screwdrivers, etc.) The surface of the electro valve block must be absolutely clean and free from oil or other polluting substances. Removal: NOTE Any extraction tool (if any) that will be d Disengage the female connectors with the fixing screws with sequence indicated below. In order to guarantee right the dismounting, screw two 100 mm. Length M5 threaded rods in the holes previously used by shown in the picture below. Control o valve block (disinsertion of all the electro valves, pressure sensor and ground tabs) with appropriate load precautions. The operation must be translation of 90 mm (Min.) in the vertical axis direction guided by the two threaded rods (see image below). NOTE allow to mount it again.
RkJQdWJsaXNoZXIy MTIwNTUz