BODY 69 2.53. SUNSHADE ROLLO ASSEMBLY (SUN BLIND) REMOVAL 1. Position the Front Glass panel in the Close position. Open Rollo to complete open position. 2. Remove complete sunroof assembly from car body. (Refer R+R of Sunroof). 3. Remove the Rear Glass panel from Sunroof assembly. (Refer R+R of Rear Glass Panel). 4. Manually rotate Motor pinion Anti Clockwise as shown. 5. Move the Rollo assembly from fully open position to service position as shown. 6. Remove two (2) M5 screws on both the sides of the Rollo assembly as shown. 7. Remove the Inner seal from the guide rail on either side up to a certain length so that there is enough space to remove the slider. 8. Slightly loosen the Slider and remove it from the cable carrier on either side of the Rollo assembly. 9. Remove the Rollo assembly from the sunroof by slowly sliding & lifting It upwards. NOTE Observe the Slider position/orientation before removal from the guide rail and cable carrier; label and mark if necessary. FITMENT For fitment follow reverse procedure of removal. NOTE After installing the Rollo, manually rotate the motor pinion clockwise extend the Rollo fabric about 50cm to see if the Rollo spring entered the blind rail. Notice that if the spring does not enter blind rail correctly, it will cause Rollo fabric to curl or tear.
RkJQdWJsaXNoZXIy MTIwNTUz