DRIVESHAFT (AT) 16 FITMENT OF LH DRIVESHAFT 1. Insert the driveshaft at knuckle end & rotate the driveshaft nut to pull the driveshaft in knuckle. 2. Insert driveshaft in gearbox end gently. Use special tool 541258902603 to avoid damage to oil seal. Do not fully engage the half shaft until the oil seal protector has been removed. Pull on the half shaft inboard joint to make sure the retainer ring has fully engaged and retains the half shaft inboard joint within the transmission. Pull on the half shaft inboard joint to make sure the retainer has fully engaged and retains the half shaft inboard joint within the transmission. 3. Insert the LCA ball joint in knuckle & tighten the mounting fastener with torque .4.9 ± 0.7 kgm & angular torque 180°±5°. 4. Insert the tie rod ball joint & tighten the nyloc nut to knuckle at torque 11.5-15.5 kgm. 5. Tighten the drive shaft nut with spacer to torque 30 ± 1.5 Kgm. NOTE: To restrict rotation of driveshaft apply Brake.
RkJQdWJsaXNoZXIy MTIwNTUz